Bendix-commercial-vehicle-systems SMARTIRE TPMS HAND TOOL MANUAL Manual do Utilizador

SmarTire® TPMS Maintenance Hand Tool Revision 1.04 User Manual ®

Page 10Maintenance Tool Software Update Program Figure 5 Updating The Maintenance Tool Figure 6 psi/BAR/kPa/C/F - Measurement Units This functi

Page 11Delete Sensors in Memory This function is used to delete all sensor data stored in the Tool memory. Walk-Around Learn Walk-Around Learn Pro

Page 12 8. After the last tire has been learned, press the down arrow. The Tool is now ready to transmit this information to the vehicle’s tire p

Page 13 13. Make sure the number of tires entered on the Tool matches the number of tires being monitored on the vehicle and then repeat the Walk-A

Page 14TRAILER COLD INFLATION PRESSURES (CIP) Program CIP of Axles in TrailerLink™ System by Bendix CVS ECU CIP Programming Procedure TPMS pre

Page 15 6. When the CIP values have been adjusted to the desired setting, press and hold the Return button for 3 seconds until the programming sc

Page 1612. In the case of a programming error, the failure screen (shown below). If this occurs, ensure the TrailerLink™ system by Bendix ECU is po

Page 176. Using the Maintenance Hand Tool, go to the first tire to be programmed and proceed to activate each of the trailer’s tire pressure sensor

Page 189. If a sensor failed to activate, this screen will be appear: If this occurs, ensure that the Tool is placed at the correct position aroun

Page 1914. In the case of a programming error, the following screen is shown. 15. If this occurs, ensure the TrailerLink system ECU is powered and

Page 2

Page 20 Figure 10 Sensor Learn Screen Execution Icons ICON STATE DESCRIPTION  Confirm Good X Cancel Cancels current action. Back Back, Se

Page 21Troubleshooting Examples Figures 11 through 14 show examples of potential screens after activating a sensor (within LF sensor range) using t

Page 22 Figure 14 Sensor not found Specifications Hardware Specifications General Specifications  Handheld 125 kHz LF generator. (To provide act

Page 23Radio Frequency Specifications Receiver Specifications PARAMETERS CONDITION VALUE UNITS RF Frequency - 433.92 MHz Receiver Sensitivity (

Page 24Troubleshooting Problem Potential Solution The Tool does not power up or turns off when the Initiate button is pressed. Replace batteries.

Page 25 Duplication of this document in whole or in part for any purposes other than those for which it was originally intended, without the writt

Page 3 Table of Contents FCC Compliance Label ...

Page 4FCC Compliance Label The FCC compliance label is located on the back of the Tool as shown in Figure 1. Figure 1 This device complies with

Page 5Introduction The tire pressure monitoring system consists of a tire pressure sensor inside the tire that transmits a radio frequency (RF) sig

Page 6Main Menu Figure 3 Initiate Function If the Initiate button is pressed, the Tool retrieves the sensor ID, pressure data and battery status

Page 7Main Menu Icon Legend ICON STATE DESCRIPTION Handheld Battery Life These icons indicate the battery life of the handheld device

Page 8Example Display Figure 4 Set-up Menu Icon Legend Selecting the Setup button commands the Tool into Setup mode. ICON STATE DESCRIPTION

Page 9Set-up Menu Icon Explanations Software Update The software update function is used to download the latest SmarTire® by Bendix CVS Maintenanc